RCCEx CRS Extended Features

Collaboration diagram for RCCEx CRS Extended Features:

Macros
#define	__HAL_RCC_CRS_FREQ_ERROR_COUNTER_ENABLE()
	Enable the oscillator clock for frequency error counter.
#define	__HAL_RCC_CRS_FREQ_ERROR_COUNTER_DISABLE()
	Disable the oscillator clock for frequency error counter.
#define	__HAL_RCC_CRS_AUTOMATIC_CALIB_ENABLE()
	Enable the automatic hardware adjustment of TRIM bits.
#define	__HAL_RCC_CRS_AUTOMATIC_CALIB_DISABLE()
	Enable or disable the automatic hardware adjustment of TRIM bits.
#define	__HAL_RCC_CRS_RELOADVALUE_CALCULATE(__FTARGET__, __FSYNC__)
	Macro to calculate reload value to be set in CRS register according to target and sync frequencies.

Detailed Description

Macro Definition Documentation

__HAL_RCC_CRS_AUTOMATIC_CALIB_DISABLE

#define __HAL_RCC_CRS_AUTOMATIC_CALIB_DISABLE

(

)

Value:

CLEAR_BIT(CRS->CR, CRS_CR_AUTOTRIMEN)

Enable or disable the automatic hardware adjustment of TRIM bits.

Return values

None

Definition at line 3868 of file stm32h7xx_hal_rcc_ex.h.

__HAL_RCC_CRS_AUTOMATIC_CALIB_ENABLE

#define __HAL_RCC_CRS_AUTOMATIC_CALIB_ENABLE

(

)

Value:

SET_BIT(CRS->CR, CRS_CR_AUTOTRIMEN)

Enable the automatic hardware adjustment of TRIM bits.

Note

When the AUTOTRIMEN bit is set the CRS_CFGR register becomes write-protected.

Return values

None

Definition at line 3862 of file stm32h7xx_hal_rcc_ex.h.

__HAL_RCC_CRS_FREQ_ERROR_COUNTER_DISABLE

#define __HAL_RCC_CRS_FREQ_ERROR_COUNTER_DISABLE

(

)

Value:

CLEAR_BIT(CRS->CR, CRS_CR_CEN)

Disable the oscillator clock for frequency error counter.

Return values

None

Definition at line 3855 of file stm32h7xx_hal_rcc_ex.h.

__HAL_RCC_CRS_FREQ_ERROR_COUNTER_ENABLE

#define __HAL_RCC_CRS_FREQ_ERROR_COUNTER_ENABLE

(

)

Value:

SET_BIT(CRS->CR, CRS_CR_CEN)

Enable the oscillator clock for frequency error counter.

Note

when the CEN bit is set the CRS_CFGR register becomes write-protected.

Return values

None

Definition at line 3849 of file stm32h7xx_hal_rcc_ex.h.

__HAL_RCC_CRS_RELOADVALUE_CALCULATE

#define __HAL_RCC_CRS_RELOADVALUE_CALCULATE	(		__FTARGET__,
			__FSYNC__ )

Value:

(((__FTARGET__) / (__FSYNC__)) - 1U)

Macro to calculate reload value to be set in CRS register according to target and sync frequencies.

Note

The RELOAD value should be selected according to the ratio between the target frequency and the frequency of the synchronization source after pre-scaling. It is then decreased by one in order to reach the expected synchronization on the zero value. The formula is the following: RELOAD = (fTARGET / fSYNC) -1

Parameters

__FTARGET__	Target frequency (value in Hz)
__FSYNC__	Synchronization signal frequency (value in Hz)

Return values

None

Definition at line 3880 of file stm32h7xx_hal_rcc_ex.h.